RND power RND 320-00171 Bedienungsanleitung Seite 3

WHEN CONNECTED TO ANY APPLIANCE, BE SURE TO TURN ON INVERTER
FIRST. AND THEN, TURN ON THE POWER SWITCH OF THE APPLIANCE.
Optional accessory : Remote control
REMOTE CONTROL OPERATION :
WHEN CONNECTED TO ANY APPLIANCE, BE SURE TO TURN ON
INVERTER FIRST. AND THEN, CONNECT WITH THE REMOTE CONTROL
WELL AND TURN ON THE SWITCH OF REMOTE CONTROL.
CAUTION :
DO NOT REVERSE INPUT.
USE RED BATTERY CORD TO CONNECT
(+) OF A DC BATTERY TO (+) TERMINAL.
AND THEN, USE BLACK BATTERY
CORD TO CONNECT (-) BATTERY TO (-)
TERMINAL.
3
EN
CHASSIS EARTH:
THE CHASSIS EARTH LUG SHOULD BE
CONNECTED TO AN EARTH POINT, WHICH
WILL VARY DEPENDING ON WHERE
THE POWER INVERTER IS INSTALLED.
IN A VEHICLE, CONNECT THE CHASSIS
GROUND LUG TO THE CHASSIS OF THE
VEHICLE. IN A BOAT, CONNECT TO THE
BOAT'S GROUND SYSTEM. IN A FIXED
LOCATION, CONNECT TO EARTH.
WHEN THE INVERTER OPERATES IN FULL OUTPUT CAPACITY FOR A LONG
PERIOD, THE TEMPERATURE OF THE INVERTER WILL INCREASE AND
POTENTIALLY SHUT DOWN BY THE OVER-TEMPERATURE PROTECTION.
THEREFORE, IT IS RECOMMENDED TO REDUCE THE AC OUTPUT CAPACITY IF A
LONG CONTINUOUS OPERATING TIME IS REQUIRED.
Condition
Input Over Voltage
Low battery alarm:
Overheating alarm:
Overload alarm:
Note: BEEE is a 2-sec long beep, BEE is a 1-sec long beep, BI is a short beep
DO NOT USE THIS DEVICE WITH FLUORESCENT LAMPS.
Warning signal cycle Shutdown signal cycle
No Warning Signal Continuous tone
BEEE (Cycling) Continuous tone
BEE (Cycling) Continuous tone
BI (cycling) Continuous tone
WARNING FLUORESCENT LAMP
EN
4