RND power RND 320-00171 Bedienungsanleitung Seite 2

USEFUL APPLICATIONS
RUN NOTEBOOK COMPUTERS, RADIOS, TVS, VCRS,
LAMPS, FANS, FAX, DRILL, . . . . . . ETC.
SPECIFICATION
INPUT VOLTAGE RANGE : DC 20~30V (24V)
STANDBY INPUT CURRENT : <0.3A (24V)
OUTPUT VOLTAGE (AC) : 230V
OUTPUT WAVEFORM : MODIFY SINEWAVE
OUTPUT FREQUENCY : 50Hz
CONTINUE OUTPUT POWER : 1700W
PEAK OUTPUT POWER : 3400W
EFFICIENCY : 85~90%
BATTERY LOW PRE-ALARM : 21 ± 1V (24V)
BATTERY LOW SHUTDOWN : 20 ± 1V (24V)
THERMAL PROTECT : 60 ± 5℃(MICROCONTROLLER )
OVERLOAD PROTECT : YES (MICROCONTROLLER )
OUTPUT SHORT PROTECT : YES ( MICROCONTROLLER )
BATTERY EX. 12V / 24V PROTECT : YES ( MICROCONTROLLER )
BATTERY POLARITY PROTECT : YES (BY FUSE )
FUSE : 15A*8PCS (24V)
DIMENSION ( L *W*H) mm : 360*195*80
WEIGHT : 3.9 KG
TROUBLESHOOTING
IF THE INVERTER DOES NOT APPEAR TO BE FUNCTIONING
PROPERLY, THERE ARE SEVERAL REASONS WHY THE
INVERTER MAY NOT BE RESPONDING.
1
EN
1) POOR CONTACT
2) RECEPTACLE HAS NO POWER
DAMAGED FUSE. *CHECK RECEPTACLE WIRING. REPAIR IF
NECESSARY
3) FUSE IS BLOWN
REPLACE FUSE WITH A FUSE OF EQUIVALENT VALUE.
4) OVERLOAD CAUSED AC OUTPUT REDUCE *
WATTAGE OF YOUR LOAD TO LOWER THAN 1500 WATTS.
5) THERMAL CAUSED AC OUTPUT REDUCE
LOADS FOR EXTENDED PERIODS OF TIME. THE AC INVERTER WILL
REDUCE OUTPUT TO PREVENT DAMAGE TO EXCESS HEAT. IF THIS
HAPPENS, PLEASE PROCEED AS BELOW :
(A) SWITCH OFF THE POWER SWITCH OF THIS INVERTER.
(B) DECREASE LOAD OF THIS MACHINE I. E. DISCONNECT
SOME OF THE APPLIANCES OR WAIT UNTIL THIS
INVERTER BECOME COOL.
(C) SWITCH ON THE POWER SWITCH OF THIS INVERTER.
6) LOW-BATTERY SHUTDOWN
RESUME OPERATION.
CAUTION
ALWAYS PLACE THE INVERTER IN AN
ENVIRONMENT WHICH IS:
(A) WELL VENTILATED
(B) NOT EXPOSED TO DIRECT SUNLIGHT
OR HEAT SOURCE
(C) OUT OF REACH FROM CHILDREN
(D) AWAY FROM WATER/MOISTURE, OIL
OR GREASE
(E) AWAY FROM ANY FLAMMABLE
SUBSTANCE
*CLEAN CONTACT PARTS THOROUGHLY.
*CHECK FUSE, REPLACE
*THE FUSE IS LOCATED INSIDE THE PCB,
*UNDER HEAVY
*RECHARGE YOUR BATTERY AND
EN
REDUCE THE
2