Tjep Rc20A/Rc30A Blade; General Operating Cautions - Tjep Rc30A Bedienungsanleitung

TJEP RC20A/RC30A blade

The blade for the TJEP RC20A/RC30A Rod Cutter should be replaced when the blade is dull or
chipped and a noticeable increase in cutting time has occurred.
To change the blade, remove battery, remove the 4 screws (pos. 1) that hold the blade cover to the
body (4). Remove the cover (pos. 2) and unscrew the 4 bolts (pos. 3) holding the blade to the hub.
The replacement blades that you purchase have new screws to be used when installing the new
blade. Make sure that when you remove the blade you clean out the head of any metal debris that
has not escaped the tool.

General operating cautions

• The following describe the general cautions on operating tool. Always observe the cautions stated
in each item.
• Do not press the operation switch if the tool is pointed towards anyone. Operating the tool by
holding it toward anyone may cause injury from contact with the blade.
• Do not apply the TJEP RC20A/RC30A Rod Cutter for purposes it is not intended.
Do not use the tool for lifting or hammering etc. instead, only use this tool for cutting. Otherwise, the
main unit may be broken or damaged, causing injury.
132