Installing And Removing Battery; Battery Capacity Indicator; Check The State Of Your Work Site; Remove Hazardous Substances - Tjep Rc30A Bedienungsanleitung

nals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out
or damaged.

Installing and removing battery

Do not use force when inserting the battery. To insert the battery, align the tongue on the battery
` Inserting battery
with the groove in the housing and slip into place. Always insert it all the way until it locks in place
with a little click. If not, it may accidentally fall out of the tool.
` Removing battery
Button
1. Push the button as 2. Withdraw it from the tool
the picture while sliding the button

Battery capacity indicator

If you press the switch on the bottom of the power tool, the LED light will turn off after a few seconds.
Check the battery levels as follows.

Check the state of your work site

Before using the tool, check whether the state of the work site is as follows. Is the worksite free of
foreign objects, debris, water, ice, snow, powered electrical cables, and excessive dust? Is the floor
free of obstructions? Is their adequate ventilation? Is the worker properly insulated from the ground.
Follow the operation instructions and avoid prohibited items.

Remove hazardous substances

130
Remaining
battery
button
Battery capacity
indicator
Remaining battery
Indicator
3 light on
2 light on
1 light on (Below) 80%
1 flickering
capacity
(Over) 80%
(Over) 50%
80% or less