Troubleshooting - Alpha Techno AT-18328X Bedienungsanleitung

Troubleshooting

07
Problem
The product does
not work
The product is
abnormally warm
Noise can be heard
from the product
28
Possible Cause
The product is not plugged
in properly.
The product has just
finshed its auto timer
session and has
automatically switched to
standby mode.
You may have used the
product continuously for 45
minutes where the over
heat protection has been
activated.
An excessive load has
been applied on the
product.
The product is likely to be
overused.
Noise is made by the
mechanical parts of the
product.
Suggestion
Ensure the voltage on the
product corresponds to the
local mains voltage and
then plug in again.
If you want another
session, press the On/Off
button again.
Unplug the product and let
it cool down for 60 minutes
before you use it again.
Reduce the excessive load
and start again.
Unplug the product and let
it cool down before using
it again.
This is normal and does
not mean that the product
is faulty.