Troubleshooting - Alpha Techno AT-301 Bedienungsanleitung

Troubleshooting

07
Problem
The product does
not work
The product is
abnormally warm
Noise can
heard from the
product
33
Possible Cause
The product is not
plugged in properly.
The product has just
finshed its auto timer
session and has
automatically switched to
standby mode.
You may have used the
product continuously for
45 minutes where the
over heat protection has
been activated.
An excessive load has
been applied on the
product.
be
The product is likely to be
overused.
Noise is made by the
mechanical parts of the
product.
Suggestion
Ensure the voltage on
the product corresponds
to the local mains voltage
and then plug in again.
If you want another
session, press the On/Off
button again.
Unplug the product and
let it cool down for 60
minutes before you use it
again.
Reduce the excessive
load and start again.
Unplug the product and
let it cool down before
using it again.
This is normal and does
not mean that the
product is faulty.