Inventum VDW8030B Benutzerhandbuch Seite 40

Cleaning the condenser unit
Please clean the condenser unit approximately once every 3 months
if it is frequently used.
Do not damage the condenser unit!
1. Leave the dryer to cool down.
2. Residual water may leak out, place an absorbent cloth under
the maintenance cover.
3. Unlock the maintenance cover.
4. Completely open the maintenance cover.
5. Remove lint and fluff from the condenser unit using a vacuum cleaner with
a dusting brush attached. Do not apply any pressure. Otherwise, the condenser
unit could be damaged. The dryer will not dry if the cooling fins are damaged
or bent.
6. Clean the seals.
7. Close the maintenance cover until it locks into position.
WARNING! Do not use hard/sharp-edged objects!
Do not operate the dryer without the condenser unit!
Troubleshooting
Many malfunctions and faults that might occur in daily operation can be easily remedied.
Time and money will be saved because a service call will not be needed.
The following guide may help you find the reason for a malfunction and correct it.
Display Reason
Condensate tank is full
Water pump failure or water level sensor
failure
E33
Temperature sensor error
E64
BLDC motor communication error
E82
PCB communication error
• Only authorized technicians can carry out repairs.
• If the display shows a different error code and the dryer does not work, please call the customer service.
• Before you call the customer service, please check if you can resolve the problems yourself by
consulting the user instructions.
Solutions
Empty the condensate tank.
Please contact the customer service if the problem
persists.
40
English•