Assmann Concepta Montageanleitung Seite 8

C O N C E P TA M O N T A G E A N L E I T U N G | I N S T R U C T I O N S H E E T
Fundamental safety information.
Incorrect assembly puts your health at risk. Assembly must only
be carried out by trained personnel.
Required assembly personnel: 2 persons (expert staff).
No liability is accepted for assembly mistakes.
The furniture is only guaranteed to work properly if it is installed
in the correct vertical and horizontal position.
All screws and supporting connection parts and fittings should
be re-tightened after several weeks.
14
Care instructions.
Melamine resin-coated surfaces
Cleaning with a damp, lint-free cloth is basically recommended. The cloth
should be dampened with fresh water without adding cleaning agent,
furniture polish or the like.
If cleaning with a damp cloth is not sufficient, careful use of a mild plastic
cleaner that does not contain scouring agent is permitted.
Alternatively, special cleaning agents can be used that are also used for
surface cleaning at ASSMANN BÜROMÖBEL GMBH & CO. KG. If you have
any questions, please speak to your designated field service contact.
Natural wood surfaces
A soft, lint-free cleaning cloth that may be slightly damp is sufficient for
daily cleaning.
Do not use aggressive acids, alkalis or solvents.
Scouring cleaning agents must also be avoided, since these will cause
permanent damage to the appearance.
Wooden surfaces must not be cleaned with normal commercial furniture
cleaner or furniture polish.
Exclusion of liability.
In the following circumstances, the Company ASSMANN BÜROMÖBEL
GMBH & CO. KG may be excluded from liability:
■ if the product is used other than as an item of office furniture
■ if the item is used for purposes other than those for which it was intended
■ in cases of incorrect assembly by unauthorised specialist staff
■ if the product is operated with defective or non-functioning protection
and safety devices
■ in cases where loads exceed the upper thresholds of those prescribed in
the user information
■ in cases of improper maintenance
■ where there has been a failure to check the system components
■ in cases of resale to third parties, if the user information has not been
passed on to this user
■ if the construction and functioning of the product are altered in
unauthorised ways
C O N C E P TA
15