Interface Installation - Ohaus Ranger 7000 Bedienungsanleitung

Ethernet Interface
INTRODUCTION
This Ethernet interface kit is for use with the Ranger
KIT CONTENTS
 Pressure button
 Screws (5)

INTERFACE INSTALLATION

Only one interface module can be installed in the terminal option slot at a given time.
Install the Ethernet Interface on the underside of the balance as shown.
1. Release the two screws, remove the red interface options cover, and unplug the black rubber insert.
2. Install the Interface PCB. Push it through the pins and secure it with the 3 screws.
Pins
 Cable
 Ethernet PC Board
Cord groove
Screws
®
7000 scales.
EN-1