Tesla Smart Indoor Irrigation System Benutzerhandbuch Seite 3

INSTALLATION
Setup the main unit
1. Plug in the USB cable
2. When power is on, the LED indicators light up and then turn
off in a few seconds.
3. Reset the device by pressing and holding the control button
(2) for 5 seconds. Blue LED will start blinking and the unit is now
in pairing mode.
Connect the hoses
1. Cut the tubing according to the position of the pump, water
reservoir and number of pots.
2. Soaking the head of tubing into hot water for 10s or applying
a little vegetable oil on the end of the tubing will ease the
installation.
3. Connect the tubing to the water inlet and outlet (6, 7)
4. Use T fittings to split the watering lines. To avoid leaking ,
make sure the fittings are pressed as deep into the tubing as they
can go.
5. Press the drippers into the tubing. Press the drippers deep
enough into the soil to make sure water goes to the roots.
6. If needed, insert the end plug into the end of tubing.
7. If needed, use the hook at the back of the main unit to attach it
to the water reservoir.
Correct position of the kit
1. Place the main unit higher than the reservoir water level, and
make sure the first dripper is higher than the top of the water
level in the water reservoir to effectively avoid the siphoning
phenomenon. (The siphoning effect will cause the water leaking
and over-watering problem).
2. We recommend that the height difference between pots and
the water pump does not exceed 3m.
Testing before use
Congratulations, you have completed the connection and insta-
llation of the drip irrigation kit. Please test the watering lines for
leaks to avoid water damage before letting the kit run remotely.
You can turn the pump on by pressing the control button (2).
3