Extra Information; Troubleshooting; Troubleshooting Table - Inventum Vvw6036Aw Benutzerhandbuch

2. Pull the lower spray arm (A) upwards to remove it.
3. Clean the spray arms. Use soapy and warm water and use a soft brush to clean the jets.
4. Hold the nut (A) in the center still and rotate the upper spray arm (B) clockwise.
5. Push the lower spray arm (A) down to put it back.
8

Extra information

WATER HARDNESS LEVEL SETTINGS (SALT CONSUMPTION)
German hardness
Level
[dH]
H1 0-5
H2 6-11
H3 12-17
H4 18-22
H5 23-34
H6 35-50
9

Troubleshooting

GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the fault codes.
2. If the fault code keeps re-occuring, contact the Inventum-servicedienst.

TROUBLESHOOTING TABLE

Problem
The program does not start.
The detergent reservoir contains
detergent residues.
The appliance contains water when
the program is finished.
French hardness [dF] British hardness [dE]
0-9 0-6
10-20 7-14
21-30 15-21
31-40 22-28
41-60 29-42
61-90 43-63
Possible cause
The mains plug is not connected.
There is a problem with the fuse.
There is no water supply.
The door of the appliance is open.
The appliance is switched off.
The water inlet hose and filters are
clogged.
The detergent reservoir is filled while
the reservoir was still damp.
The drain hose is clogged or twisted.
Program selector button on
Quick '30, on
Quick '90, on
Quick '90 and Quick '30, on
Eco, on
Eco and Quick '30, on
Eco and Quick '90, on
Possible solution
Connect the mains plug.
Do a check on the fuse box.
Open the water tap.
Close the door.
Start the appliance. Refer to section
Starting the appliance
.
Make sure that the water inlet hose
and the filters are not clogged.
Make sure that you fill the detergent
reservoir when it is dry.
• Make sure that the drain hose is
not clogged.
• Make sure that the drain hose is
not twisted.
English
(Figure 29)
(Figure 30)
(Figure 31)
• 47