HIKMICRO HABROK Serie Schnellstartanleitung Seite 9

English
4. Install Battery (Page 1 – B)
Steps:
1. Unlock and open the battery compartment cover.
2. Insert batteries into the battery compartment as the positive and negative marks indicate.
3. Close the battery compartment cover and lock it.
Note
Charge the device for more than 5 hours before first use.

Remove the battery if the device is not used for a long time.

The external rechargeable battery type is 18650, and the battery size should be 19 mm × 70 mm. The rated

voltage is 3.6 VDC, and the battery capacity is 3200 mAh.
To ensure better conductivity, if the battery compartment cover gets dirty, use a clean cloth to wipe the

thread.
5. Mount Neck Strap (Page 2 – C)
Steps:
1. Thread one end of the neck strap through a neck strap attachment point.
2. Thread the neck strap through the strap buckle and fasten the neck strap, as is shown in the picture.
3. Thread the neck strap through the strap keeper.
4. Repeat above steps to finish mounting, and adjust the length of neck strap as needed.
6. Mount Tripod Adapter (Page 2 – D)
Steps:
1. Insert the location column (1) to the location point (2).
2. Rotate the tripod adapter screw clockwise to fix the tripod adapter.
7. Charge Device (Page 3 - E)
Steps:
1. Lift the type-C interface cover.
6