Kruger & Matz KM0232-SA Bedienungsanleitung Seite 7

damages, liquid has been spilled or objects has been
dropped on the device.
11. Keep the device in a well ventilated area.
12. Do not expose the batteries to excessive heat.
13. Make sure that the voltage of the device and voltage in
the outlet matches.
14. Do not connect the device to a power strip with too
many other electronic components.
15. When unplugging the device, hold the main plug, not the
wire.
16. Remove the batteries from the remote if it not going to
be used in a long time.
17. Do not mix old and new batteries. Do not mix batteries
of a different kind. Use consumer grade, non-rechargable
alkaline batteries.
18. Place the TV on flat and stable surface.
19. Always connect the device to a power outlet with
protective ground connection.
20. To provide maximum stability, use the stands that are
included in the box.
21. Always place the device on stable surfaces that can
support its weight.
22. Always route the cables in a way, so that they cannot be
tripped over, pulled or grabbed.
23. Do not press hard or put pressure on the LCD panel. It can
cause the panel to brake, shatter or make permanent marks.
24. If the panel does brake, do not make contact with the
liquid in the panel. This can cause skin irritation. If the
liquid gets on your skin, rinse the skin for 15 minutes. If
the liquid gets in your mouth, immediately gargle and
consult your doctor.
EN
12
Owner's manual Owner's manual
INSTALLATION
Mounting the stand
1. Place the TV with the front panel facing downwards.
Make sure to place the front panel on soft cloth, soft
pads or another soft piece of material.
2. Insert the stand into the holes located on the bottom of
the TV (L for left, R for right).
3. Insert the screws into the sockets and tighten them.
Mounting on the wall
The TV has VESA mounting holes for wall mounting bracket
(not included). Make sure that your bracket is the
compatible one with the TV. VESA standard determines the
width and height of the mounting holes for the bracket.
Before mounting the TV on the wall:
• Follow all instructions from the wall mount manufacturer.
• If you have any doubts about your ability to safely install
the TV on the wall, contact a professional.
• Make sure that the wall can support the weight of the TV
and the mount.
• When installing the TV on the wall, do it with someone to
help you.
• Make sure that the TV has at least 20 cm clearance from
each side.
EN
13