Safety Systems; Maintenance - Gorenje DFGA9575BX Betriebsanleitung

CONTROLS
P1: Filter alarm reset
P2: Motor on/off - 1st speed
P3: 2nd speed
P4: 3rd speed
P5: 4th speed
P6: Lift panel up/down (during opening the panel can
be stopped at the desired height by pressing the
button a second time).
5' Timer function:
Holding the buttons P2, P3, P4 or P5 pressed down
(>2") the 5' Timer function is activated. When the
time has run out, the motor turns off and the lift
closes. The LEDs change from High to Low intensity.
When the function is active, the LED corresponding
to the current motor speed blinks.
Filter alarm display:
Grease filters: After 30h of motor operation, the LED
of the P1 button comes on for 30'' every time the
motor turns off.
Charcoal filter: After 120h of motor operation, the LED
of the P1 button blinks for 30'' every time the motor
turns off.
CONTROLS
P1: Motor on/off - 1st speed
P2: 2nd speed
P3: 3rd speed
P4: 4th speed
P5: Lift panel up/down (during opening the panel can
be stopped at the desired height by pressing the
button a second time).
5' Timer function:
When the motor is on, holding the keys P1-P4
pressed down (depending on the speed set), the 5'
timer function is activated. When this function is
active, the LED corresponding to the speed (L1-L4)
blinks. When the 5' have elapsed, the motor turns off
and the carriage closes.
Filter alarm display:
After 30 hours of motor operation, the LEDs L1-L5
come on for 30'' each time the motor is turned off.
After 120 hours of motor operation, the LEDs L1-L5
blink for 30'' each time the motor is turned off.
To reset the alarm, press any one of the keys P1-P5
for 2" during alarm display.
ATTENTION
!

SAFETY SYSTEMS

In order to function correctly the product is equipped
with a series of safety devices which are also
intended to prevent any injury caused by
inappropriate use.
In any case be very careful in using the product,
above all the parts in motion.
ALARM ON CONTROL (all models)
1. All LEDs flashing: this means that the telescopic
trolley is locked. Wait 30" and then press the UP/
DOWN button to release the trolley
2. UP/DOWN button LED flashing: this means that
the front panel of the filters is not closed properly.
Reposition it correctly.

MAINTENANCE

! Before cleaning or maintenance cut the power.
If the light spot is damaged, it must be replaced only
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard
Cleaning the hood
WHEN TO CLEAN IT: clean it at least every 2
months to prevent the risk of fire.
EXTERNAL CLEANING: use a cloth moistened in
lukewarm water and neutral detergent (for painted
hoods); use specific products for steel, copper or brass
hoods.
INTERNAL CLEANING: use a cloth (or brush) soaked
in denatured ethyl alcohol.
WHAT NOT TO DO: do not use abrasive or corrosive
products (e.g. metal sponges, brushes, too hard
brushes, very aggressive detergents, etc.)