Data Synchronization - LAMAX TECH BFit Betriebsanleitung

Installing the mobile app and pairing the fitness band
The fitness band is compatible with iOS (7.0 and higher) and Android
(4.3 and higher). Download the LinkFit mobile app to control the fit-
ness band from the following link:
http://tech.lamax-electronics.com/ http://tech.lamax-electronics.com/
BFit/BFit-app-app-store BFit/BFit-app-google-play
Enable Bluetooth on your smartphone. Turn on your Bfit band.
When the band is not paired, it is in search mode and this icon .
appears next to the time display, above the battery status. Open the
LinkFit app on your smartphone. If your phone is not already paired
with the fitness band, it will appear on the Device Scan page in the
app. Choose the band with your identification number and confirm
this pairing with your phone (Android – Confirm, iOS – Pair). The
identification number is displayed on the fitness band screen when
it is turned on. Pairing should be complete within a minute. If after
a minute the pairing notification does not appear, repeat the abover
procedure. Once paired, this icon appears next to the time and abo-
ve the battery status. When paired the fitness band can be seen in the
app Device Connected settings. After pairing the app will ask you to
enter your gender, weight, height and daily step target.

Data synchronization

The fitness band automatically syncs with the app after pairing with
your smartphone via Bluetooth. The band displays the precise time
and synchronizes the pedometer data, calories burnt and distance
travelled. The initial data synchronization takes approximately one
or two minutes. Data can be synchronized manually in the app by
touching the icon . If data is not synchronized, turn Bluetooth off
and on again.
Sleep monitor
Scroll across the screen from left to right using your finger until you
reach this icon . Then touch and hold the display. The band then
briefly vibrates and displays the exact time together with the icon
. Sleep monitoring is now enabled. Turn off sleep monitoring by
pressing and holding the display in this mode. The display will light
up, vibrate briefly and the connection icon reappears next to the
time. Automatic sleep monitoring can also be enabled in the app. In
the settings turn on the Autosleep function. Sleep monitoring is now
automatically enabled between 8 pm and 9 am.
3