For All Models; Cleaning And Care - Melinera EM 3D Bedienungs- Und Sicherheitshinweise

The connecting cable cannot be repaired! If the
cable is damaged, the product must be taken
out of use and disposed of in the proper way.
This product does not contain any parts which
can be serviced by the user. The bulbs cannot
be replaced.
The illuminant is not replaceable.
If the illuminant fails at the end of its life, the
entire light must be replaced.
Never open any of the electrical parts or insert
any kind of object into them.
Do not open or cut the rope light.
Protect the product from sharp edges, mechanical
loads and hot surfaces.
Do not install with sharp fasteners or nails.
Always remove the mains plug from the socket
before installing, dismantling or cleaning.
Never touch the mains plug or the 3D rope light
figure with wet hands.
CAUTION! RISK OF OVERHEATING! Do
not cover the rope light with blankets, cushion
or similar heat-insulating material. Do not oper-
ate the product whilst it is still in the packaging.
Use the lighting only with the parts described
in these instructions.
If the product is not to be used for any length
of time (e.g. holidays), disconnect it from the
power supply.
After use store the product in the original pack-
aging to avoid causing unintentional damage.
Keep the product away from ponds and other
bodies of water. Install the product at least 2 m
from water containers. Avoid locations where
flooding occurs after heavy rain.
Use the product outdoors only when connected
to a mains socket protected by a residual-
current device (RCD) with a rated trip current
of not more than 30 mA.
Outdoor mains sockets must be suitable for use
outdoors and should be at least 2.5 m from the
nearest water container or body of water.
The product is protected against splash water
(IP44). This protection standard is only possible
if the mains socket also fulfills requirements of
at least the same protection class.
Ensure that the product is not laid out through
areas in which lawn mowers, strimmers, shears
or similar cutting tools are used.
Ensure that the product does not present a trip
hazard.
If you have any questions about the product or
are unsure about any of its aspects, please seek
the advice of an electrical equipment specialist.
Installation
Only for Z31531E (Christmas tree):
Bend the two wire elements carefully out from
one another.

For all models:

Stand the 3D rope light figures
substrate.
If possible fix the 3D rope light figures
place with the ground spikes
Check the stability of the 3D rope light figures
Use
Plug the mains plug
lighting is switched on.
To turn the lighting off, remove the mains plug
from the socket.

Cleaning and care

CAUTION! RISK OF ELECTRIC SHOCK!
First remove the mains plug from the socket.
Let the product cool before you clean it. Risk of
injury!
Do not use any solvents, petrol or similar items.
This would damage the device.
Only a dry, lint-free cloth should be used for
cleaning.
on a stable
1
in
1
.
3
into the socket. The
2
GB/MT
.
1
2
15