ARCADE1UP Midway Legacy Benutzerhandbuch Seite 9

Serious or fatal crushing injuries can occur from furniture tip-over.
To help prevent tip-over:
Set upArcade1UP on a level floor.
•
Never allow children to climb or hang on product.
•
Always set up an anti-tip device!
•
Use of tip-over restraints may only reduce, but not eliminate, the risk of tip-over.
WARNING: Arcade1UP assumes no liability for improper installation or excessive loads
placed on screws or bracket. This wall anchor is not a substitute for proper adult supervision.
Make sure to locate your Arcade1UP on a flat surface.
Troubleshooting
PROBLEM
Game will not turn ON.
Game will turn ON, but
there is no sound.
You hear sound but
there is no picture.
POSSIBLE CAUSE
*Power cord is not plugged
into wall outlet.
*Wires/Plugs are hooked
up incorrectly.
*ON/OFF Switch is in the
OFF position.
*Upload switch on back of
monitor is in the OFF
position.
*Wires/Plugs were hooked
up incorrectly.
*Volume Switch is in the
OFF position.
*Wires/Plugs were hooked
up incorrectly.
9
SOLUTION
*Make sure power cord is plugged
into the wall outlet and there is
power to that outlet.
(Plug other electrical equipment into
the power outlet to make sure the
outlet normally works.)
*Make sure all Wires/Plugs are
properly connected and all the way
set in as directed in assembly
instructions.
*Slide ON/OFF Switch located on
control deck to the ON position.
*Slide upload switch on back of
monitor to the ON position.
*Make sure all Wires/Plugs are
properly connected and all the way
set in as directed in assembly
instructions.
*Slide Volume Switch located on
control deck to the right.
NOTE: Push volume slide switch
right to increase volume, left to
lower volume.
*Make sure all Wires/Plugs are
properly connected and all the way
set in as directed in assembly
instructions.