Chauvet DJ D-Fi USB 2 Kurzanleitung Seite 3

Safety Notes
These Safety Notes include important information about installation, use, and maintenance of the D-Fi USB 2 and D-
Fi USB 2x4.
■ ALWAYS:
♦ Connect to a grounded circuit.
♦ Connect to operating voltages as specified on the product's spec sticker.
♦ Disconnect from power before replacing the fuse.
♦ Disconnect from its power source during periods of inactivity.
♦ Heed all restrictions and warnings on the spec sticker.
♦ Replace the fuse with the same type and rating.
■ In the event of a serious operating problem, stop using immediately.
■ DO NOT:
♦ Open this product or attempt any repairs. It contains no user-serviceable parts.
♦ Allow flammable materials close to the product when it is operating.
♦ Connect to a dimmer or rheostat.
♦ Operate in temperatures higher than 104°F (40°C).
♦ Expose to environments that exceed the Ingress Protection (IP) rating.
♦ Expose to rain or moisture.
♦ Use outdoors.
♦ Submerge.
♦ Leave outdoors for extended periods of time.
♦ Expose to corrosive environmental conditions such as temperature, humidity, salinity, pressure, radiation,
or shock.
♦ Set this product on a flammable surface.
What is Included
D-Fi USB 2
♦ D-Fi USB 2
D-Fi USB 2x4
♦ D-Fi USB 2 (X4)
FCC Statement of Compliance
This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
♦ Reorient or relocate the receiving antenna.
♦ Increase the separation between the equipment and receiver.
♦ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
♦ Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
RF Exposure Warning for North America and Australia
Warning! This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm between the radiator and the user. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
D-Fi USB 2 and D-Fi USB 2x4 QRG Rev. 1
QUICK REFERENCE GUIDE
♦ Quick Reference Guide
♦ Quick Reference Guide
EN
1