Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instruction control unit
GB
1. CONTROLS
Button - ON/OFF
Button - LIGHT
Button - MODE
Button - PLUS, MINUS
2. CHANGING THE LANGUAGE
MODE
Hold the
-button in the standby mode (dark display) for 5 seconds.
Change the language by pressing the
(German -> English -> French -> Dutch).
MODE
Confirm by pressing the
3. LIGHT
Switch the light ON/OFF by using the
with an LED spot, you have to switch it on by using the remote control.
4. SWITCHING ON THE INFRARED CABIN
ON/OFF
By pressing the
-button the cabin is switched ON/OFF. Start by pres-
PLUS
sing the
-button with steamer and the
The infrared cabin starts with the last setting values (the values remain stored
even after a power failure). The evaporator always starts with 100%.
PLUS
-button.
-button.
LIGHT
-button. If your cabin is equipped
MINUS
-button without steamer.
5. SETTINGS
1 x Mode - Infrared A-radiator1
MODE
By pressing the
-button (1x) the intensity of „radiator 1" is adjustable.
PLUS
MINUS
With
and
the radiation intensity can be adjusted from
40 to 100 % in steps of 5 %.
2 x Mode - Infrared A-radiator 2
MODE
By pressing the
-button (2x) the intensity of „radiator 2" is adjustable.
PLUS
MINUS
With
and
the radiation intensity can be adjusted from
40 to 100 % in steps of 5 %.
3 x Mode - Salt evaporator
MODE
By pressing the
-button (3x) the intensity of the salt evaporator is
PLUS
MINUS
adjustable. With
and
from 0, 40 to 100 % in steps of 10 %.
4 x Mode - Cabin temperature
Adjustment of the desired cabin temperature from 30 to 60 °C. At a cabin
temperature of 60 °C all radiators are automatically switched off for safety
reasons (at a cabin temperature of 59 °C they are activated again).
5 x Mode - Surface heating
Adjustment of the desired surface temperature of the surface heating
elements from 30 to 80 °C.
6 x Mode - Running time
PLUS
Setting of the time with
and
10 min.)
Important: The display returns to normal operation after 5 sec. without
pressing a button (on the top right side of the display the 5 sec.
are counted down).
6. SWITCHING OFF
Switching off by briefly pressing the
7. RESET TO MANUFACTORY SETTING
If you want to reset to the manufactory settings (operating time: 60 min,
cabin temp.: 60 °C, surface heating: 80 °C, infrared A radiator intensity:
MINUS
PLUS
100 %), keep the
+
The display will show:
ATTENTION !
reset to
manufactory
setting !
the evaporator intensity can be adjusted
MINUS
from 10 min to 2 h (in steps of
ON/OFF
-button.
MODE
+
-button pressed at the same time.
24
Werbung
