Sulion RAINBOW S Bedienungsanleitung Seite 14

Synchronisation of one or more fans with a single
control:
CAVEAT! Prior to syncing, make sure the ceiling fans you
don't want to sync to the same remote are turned off at the
wall switch, otherwise they might be synced too, and once
synced they can't be unsynchronized
1.- Turn on the power (wall switch) to the fans to be
controlled and then, within 5 seconds, press the
on the remote control until the fans emit a "beep" sound
or a flashing light, indicating that the connection has been
made and the equipment can operate normally.
2.- Now, the remote control and the fan receivers will have
been synchronised. Turn off the power to the fans using the
switch or the automatic switch and then turn them on again,
this step is the one that closes the synchronisation process.
Note: If the fans do not rotate in the same direction, press the
button for 5 seconds to set all the fans in summer mode.
Troubleshooting
Remote control malfunction
1.Make sure all connections are correctly made.
2.Make sure that the remote control contains batteries.
3.Make sure that all switches (main and isolation) are on.
4. Receiver resynchronization and remote control.
The receiver and remote for this fan are paired
at the factory, they do NOT need to be paired
14
once the fan is installed. Synchronization will
only proceed due to a malfunction of the remote
control. If you have questions before performing the
resynchronization, contact Sulion.
CAVEAT! Before syncing, if you have another ceiling fan
in the same or another room that you don't want to sync,
check that it is turned off at the wall switch, if not; it could
be synced also with the same remote control and once
synced it cannot be unsynchronized.
button
CIF A28763647 Calle Verano, 51 - 28850 Torrejón de Ardoz - Madrid (ESPAÑA)