Werbung
4 -
Yellow led
5 -
Green led
CONTROL PANEL (Fig. C2)
1 - Adjustment knob:
2 -
Yellow led
3 -
Yellow led
4 -
Yellow led
5 -
Green led
6 - MODE selecting knob
7 - Display leds for digital gauge air pressure
8 - AIR key
REAR PANEL (Fig. D)
1 - Power cable.
2 - Main switch O - I
I
3 - Manual pressure regulator
4 - Pressure reducer knob
5 - Fitting
5. INSTALLATION
ATTENTION!
CARRY
OPERATIONS WITH THE PLASMA CUTTING SYSTEM
STRICTLY OFF AND DISCONNECTED FROM THE POWER
MAINS.
THE ELECTRICAL CONNECTIONS MUST ONLY BE CARRIED OUT BY
EXPERT OR QUALIFIED TECHNICIANS.
PREPARATION
LIFTING MODE OF THE MACHINE
MACHINE POSITIONING
ATTENTION! Position the machine on a flat surface of
adequate capacity for the weight to avoid dangerous
turning over or movements.
CUTTING CIRCUIT CONNECTIONS
IMPORTANT!
Connecting the cutting current return cable.
OUT
ALL
THE
INSTALLATION
Werbung
