Lindy 39384 Benutzerhandbuch Seite 5

User Manual
Installation
Transmitter
1. Power LED: Indicates Power.
2. EDID: DIP switches to set up the following presets:
- COPY: Copy EDID from the display connected to the Receiver (default)
- STD: 1080p60 2CH
3. SERVICE: USB Micro-B port for firmware updates.
4. DC 24V: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the transmitter
or receiver. This is only required at one side of the installation.
5. HDBASET OUT: Connect a compatible HDBaseT receiver using a single Cat.6 or above cable for all
data signals. Please do not connect to a network port.
6. Link Indicator LED:
- Illuminated Green: Link is Okay
- Flashing: Link is poor or not stable
- Not Illuminated: No Link
7. Data Signal Indicator LED:
- Illuminated Yellow: Signal is with HDCP
- Flashing: Signal is without HDCP
- Not Illuminated: No signal
8. HDMI IN: Connect to a HDMI source device.
9. IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
10. IR OUT: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
11. PC: USB Type B Female port, connect to a USB port on a PC.
English