Hameg Instruments HM 8042 Bedienungsanleitung Seite 11

Control Panel HM 8042
CURVE TRACER HM8042
0888 3
nA CU
t)
DUT Vs/Vc_iIp/Ic
DY @ @& 4
@) Display (7 segment LEDs)
3% digit display of measurement values
and indicators of measurement parameters
(2) DUT (pushbutton)
Connect or disconnect the Device Under Test
@ X-¥ OUTPUT (jacks)
Outputs for connecting an oscilloscope
(4) E/S; C/D; B/G (jacks)
3 banana jacks for Plug-in Test Adaptor
© V,/V,; |, Ny; V/V: 1/1, (LEDs)
Indicators for the test parameter selected
© V,/V i |,/I: Vo/V>: I./I, (pushbutton)
Selection of the test parameters
@ ho hy fhe! BL ¥a7 ¥. (LEDS)
Indicators for the test parameter selected
t (pushbutton)
Selection of the parameters to be measured
(9) MEM. (pushbutton)
Storing a measured value
and displaying difference values
€ Imax. $ (pushbutton)
Selection of the max. measurement current
Subject to change without notice
Vc/Vp
BIP a m= NPN
mem. FET a » PNP 4
Imax. Vmax. fel
200 av
28 mA
alehle
(5)(6)} (8) | @0)} 42) |@4) | 46) 48) | 20)
DAN BOW YD &
) 200, 20, 2mA (LEDs)
Indicator for the measurement current (|./1,) selected
(2 BIP/FET (pushbutton)
Pushbutton for selection of either bipolar
or field effect transistors
( Vmax. $ (pushbutton)
Selection of the max. measurement voltage
{4 40,10, 2V (LEDs)
Display for the measurement voltage (V../V,,) selected
(5 NPN/PNP (pushbutton)
Selection of either NPN or PNP transistors
(@ Pmax. $ (pushbutton)
Selection of the max. measurement power
@ 4,0.4,0.04W (LEDs)
Display of the selected measurement power
48 A (pushbutton)
Activation of the cursor measurement function
{9 (pushbutton)
Selection of the cursor functions
20 TRK/ <> /MIN/MAX (LEDs)
Display of the selected cursor function
@) Knob for adjusting the test voltages
and the test currents
M3 — 8042