Tesla SMART CAMERA FLOODLIGHT BATTERY Bedienungsanleitung Seite 6

4. In this interface, you should scan the QR code in your phone
with the camera, when the camera comes out „dong dong
dong". And you can complete the configuration about 30s.
5. When connecting, you should make sure your router, mobi-
le,and camera are as close as possible. When camera added
successffully, click „
name.
SETTINGS
In „Smart Camera" interface,click „
common functions.
FAQ
Q: The device cannot be previewed properly?
A: Check whether the network is normal, you can place the
camera close to the router, and if not, it is recommended to reset
the device and add it again.
Q: Why is it still in the list of devices after reseting?
A: The reset device only resets the network configuration of
the camera, but cannot change the configuration on the App,
remove the camera, and must be deleted by the App.
Q: How to cut the camera network to another router?
A: First remove and reset the device on the App and then confi-
gure the device again by the App.
Q: Why doesn't the device identify the SD card?
A: It is recommended to plug in SD card after power cut. Con-
firm whether the SD card is normally available and the format
is FAT32. And the TF card can't be identified when the internet
environment is not good.
Q: Why I can't get the notifications with my cell phone App?
A: Please confirm that the App has been running on the phone,
and the relevant reminder function has been opened;Message
notification and authority confirmation in the mobile phone
system have been opened.
„ you could also DIY the camera's
„,you can set the camera
6