SSS Siedle SLB 800-0 Produktinformation Seite 12

Remedying faults
Fault
Light does not work
Light does not switch "On"
Light does not switch "Off"
Light does not switch "Off
completely"
Light switches "On" at the wrong
times
Cause
Mains fuse defective
Short circuit
Not switched on
in the daytime mode, photoelectric
lighting controller setting is too low
LED lamp
Mains fuse defective
The pick-up range has not been
selectively set
Movement sensor module is not
connected
Continuous movement in the
pick-up range
Program P1 with basic brightness
setting has been selected
Wind is moving trees / bushes in
the pick-up range
Sensor is picking up cars on the
road
Sudden change of temperature
due to ambient conditions
(fans, open windows, exhaust air etc.)
Remedy
Replace mains fuse
Check terminals
Switch on the power
Reset the response value
Replace LED lamp
Replace fuse and if applicable check
the installation
Readjust
Check movement sensor module and
insert into light
Check the pick-up range and adjust
if necessary, check switch or cover
affected areas
Select a different program
Alter the range or the pick-up angle
Alter the range or the pick-up angle
Alter the range or the pick-up angle
7