Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Adjust the sensor
10
Release the movement sensor
module with a flat blade screwdriver
and pull downwards.
11
Select the required program, set
the ON time and brightness value.
12
Insert the movement sensor
module and lock into place. Carry
out a function test.
Programs
The movement sensor module can
be detached for convenient setting
of the required functions. While
the movement sensor module is
removed, the light of the Select LED
lamp is switched on. Setting is per-
formed using three rotary controllers
for time, photoelectric lighting con-
troller and program setting. There
are 4 different programs to chose
from. The switch-on time can be set
within a range of 5 seconds to
15 minutes. The response threshold
can be set within a range of 2 Lux
(photoelectric lighting controller
mode) - 2000 Lux (daylight mode).
Using rotary controller P, the fol-
lowing programs / functions can be
selected:
Program 1:
Appr. 10 % basic light when the
set photoelectric lighting controller
value is reached and 100% light
on detection of movement. After
expiry of the set ON time, the lamp
switches back to the basic light
setting. Ideal for illumination of an
adhesively mounted house number.
Program 2:
100% main light when the set pho-
toelectric lighting controller value is
reached and on detection of move-
ment. After expiry of the set ON
time, the lamp is switched off again.
Program 3:
100% main light through the whole
night after the set photoelectric
lighting controller value is reached
until the value drops below the set
photoelectric controller level again
in the morning. In this setting, the
6
movement sensor function is not
functional.
Program 4:
In this setting, no basic light and no
softstop are possible. The movement
sensor module is deactivated. The
Select LED light can be switched on
and off using a switch, or via the
L´output of another Select LED light.
Restricting the pick-up range
The range and pick-up angle can be
adjusted to circumstances on site
using the provided cover panels and
the adhesive film.
13
Reducing the range
Peel the provided adhesive film off
the backing paper and stick onto the
sensor all around the upper area.
This reduces the range from around
8 m to around 4 m.
14
Pick-up angle
A complete cover panel covers an
angle of appr. 120°C, a single seg-
ment of a cover panel covers around
20°. The segments of a cover panel
can be shortened using scissors as
required.
Servicing
Statutory warranty conditions
apply. Exchange of the device
in case of Servicing must be
performed by your electrical
installer.
Technical data
•
Typical pick-up angle 180°, pos-
sible pick-up angle 360°, depending
on the installation
•
Sensor aperture angle 90°
•
Sneak-by guard, aperture angle
30°
•
LED current reduction at tempera-
tures > +40°
•
Protection class II
•
Photoelectric lighting controller
setting 2 – 2000 Lux
•
Operating voltage: 230–240 V,
50 Hz
•
Operating current: max. 50 mA
•
Colour temperature: Neutral-Weiß
4200 K
•
Light bulb: Lamp unit with 6 LEDs,
8 W total output
•
Switching time: 5 secs. to 15 mins.
•
Protection system: IP 44
•
Ambient temperature:
-20°C to +55°C
•
Dimensions (mm) W x H x D:
260 x 260 x 76
Lettering
It is possible to apply a house
number to the Select LED light. The
adhesive film can be purchased from
the Siedle lettering service.
Werbung
