Bluetooth Operation
•
Turn on the Bluetooth function on your mobile phone or any other external Bluetooth
devices.
•
Search for 'WOLF Helmet PRO' on your Bluetooth device, and pair them. When paired,
"Bluetooth Connected" is shown on the LCD screen.
•
Press Menu, to play/pause the music or answer a call. Tap Tune + or Tune – to
forward/rewind the songs. To reject the call, long-press Tune - for 2 seconds.
•
When on a call and receiving 2nd call: Sound is heard from the headset while the 1st call is
still in communicating > User can select to pick up the 2nd call via mobile phone > If pick up
the 2nd call, the 1st call is on hold > Resume the 1st call communication via mobile phone
after hang up the 2nd call.
•
If user ignores the 2nd call, no operation is needed.
•
Re-dialing, long-press Tune + for 2 seconds, it will re-dial last call. When you receive a call
through the Bluetooth function, it overrides the sound from FM/DAB+. Even pressing
Mode activates nothing until the mobile call ends.
•
After paired, the user still receives and answers a call while in Radio mode.
FM Operation
•
Press the "Mode" Button to switch to FM. Press "Enter" to confirm the setting. Long-press
Tune - or Tune + to start scanning. Stop scanning when clear signal is received.
•
Manual search by short pressing Tune - or Tune +.
•
To review the station information, press if RDS message is available from the service
provider.
•
To save and listen to your favorite stations, refer to the steps of DAB+ preset stations as
mentioned above.
•
Short press Enter key, Audio mode selected to Mono / Auto, it is only for FM mode.
Bass Boost
•
To enhance the bass performance, press Enter, "Bass" is shown on the display. To
deactivate the bass Boost function, press Enter again until "Bass" disappear from the
screen.
Boom Mic Jack
•
To connect the WOLF Boom Microphone, plug the WOLF Boom mic into the 3.5mm boom
mic jack port of the hearing protection.
Factory reset
•
All preset stations and other settings will be deleted.
•
Press and hold the Menu button, press Tune - or Tune + to find 'System Reset'. Press Enter.
Software version
•
Press Menu and then press Tune - or Tune + to find 'Software version'. Write it down here:
Safety helmet with earmuffs combination
•
The earmuffs are certified with the following helmets:
◼
Uvex Pheos s-kr (sizes M and L)
•
Other models may be compatible with the WOLF 30mm helmet clip, but the ear muffs
100410 WOLF Helmet PRO
3/56