YitaHome BFTLPT-0002 Benutzerhandbuch Seite 8

Clean Operation:
1.Empty Waste Holding Tank.
2. The waste holding tank has a 20 litre capacity,it should be
emptied when contents reach approximately 2cm below the
slide valve.
3. Make sure that the slide is pushed in completely before
separating the waste holding tank and then release the latches
on both sides, hold fresh water holding tank with both hands
and move it from above of the waste holding tank.
Do not disassemble the slide valve.
4. Carry waste holding tank to permanent toilet facility.
5. When removing the cap,make sure that the waste holding tank
is in a vertical position.
6. Atmospheric pressure and temperature changes may cause
pressure build up in lower holding tank.Caution should be taken
when first opening the slide valve or opening waste holding
tank cap (before opening waste holding tank for emptying,it is
better for you to place waste holding tank in horizontal
position,open slide valve and then close it for releasing
internal pressure).
7. To avoid splashing,slowly pour contents into permanent
toilet facility.
8. Add fresh water,replace cap and rinse tank.
9. Remove cap and pour rinse water into permanent toilet facility.
6