Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WASH CYCLES
Follow the instructions on the symbols of the garment's wash
care label. The value indicated in the symbol is the maximum
recommended temperature for washing the garment.
Cotton
Cycle designed to wash cotton garments. During the last phase of the
cycle garments will be treated with steam, that will relax the fibres.
Shirt
Use the special wash cycle to wash shirts in different fabrics and colours
to guarantee they receive the best possible care. During the last phase of
the cycle garments will be treated with steam, that will relax the fibres.
ARIEL PODS
A 30°C short cycle designed to wash a mixed load of cotton and
synthetics fabrics, recommended for the use of Ariel/PODS detergent.
Wool
All woollens can be washed with program 4, even if the label says "hand
wash only"
. For best results, use a specific detergent and wash a
maximum of 2 kg of laundry.
20°C
For washing lightly soiled cotton garments, at a temperature of 20 °C.
Cotton
Suitable for washing towels, underwear, table cloths, etc. made of
resistant linen and cotton that are moderately to heavily soiled.
Synthetics
Specific for synthetic items. If the dirt is difficult to remove, the temperature
can be increased up to 60° and powder detergent can be used too.
Mixed
A 40°C cycle for washing cotton and synthetic garments together.
Suitable for lightly soiled underwear.
Eco 40-60
For washing normally soiled cotton garments declared to be washable at 40 °C
or 60 °C, together in the same cycle. This is the standard cotton programme
and the most efficient in terms of water and energy consumption.
! As specified, this wash cycle only runs at 40 °C.
White
For heavily soiled whites and resistant colours.
Rapid 20min
Allows for varying the garment treatment duration from 20' to 60' .
- 20': this cycle refreshes your garments in just 20 minutes.
- 45': a short cycle designed for washing mixed cotton-synthetic
garments.
- 60': this cycle is designed to wash moderately soiled resistant cotton
garments at 60°C in an hour, with good washing performance. For
synthetic or mixed garments, the temperature should be lowered to 40°C.
Full Load 45 min
Suitable for washing a full load of cotton clothes moderately soiled in 45
minutes.
Duvet
For washing clothing padded with goose down, such as double or single
duvets (weighing under 3.5 kg), cushions or down jackets. Duvets should
be loaded into the drum with their edges folded inwards and no more
than ¾ of the total drum volume should be used up. For best results, it is
advisable to use liquid detergent to be poured into the detergent drawer.
Delicates 30°C
Suitable for washing very delicate garments. It is advisable to turn the
garments inside out before washing them. For best results, use liquid
detergent on delicate garments.
Rinse + Spin
Designed for rinsing and spinning.
Spin + Drain
Designed to spin and drain the water.
DISPLAY
The display is useful when programming the machine and provides a lot
of information.
B
A
The duration of the available wash cycles and the remaining time of a
running cycle appear in section A; if the Delayed Start option has been
set, the countdown to the start of the selected cycle will appear.
Pressing the corresponding button allows for viewing the maximum spin
speed and temperature values attained by the machine during the set
wash cycle, or the values selected most recently, if these are compatible
with the set wash cycle.
C
C
(see "Options")
The hourglass flashes while the machine processes the data on the basis
of the selected cycle. After a maximum of 10 minutes, the
steady lit and the final time remaining is displayed. The "hourglass" icon
will then switch off approximately 1 minute after the final time remaining
has been displayed.
The "washing phases" relative to the selected cycle and the "washing
phase" of the running cycle appear in section B:
Wash
Rinse
Spin
Drain
When lit, the symbol
indicates that the set "Delayed Start" value has
appeared on the display.
There are three levels in section C relative to the washing options.
DOOR LOCKED INDICATOR
When lit, the symbol indicates that the door is locked. To prevent any
damage, wait until the symbol turns off before opening the door.
To open the door while a cycle is in progress, press the START/PAUSE
button
; if the
symbol is off, the door can be opened.
FIRST-TIME USE
Once the appliance has been installed, and before it is used for the first
time, run a wash cycle with detergent and no laundry, by setting the
"Auto-Clean" cycle.
DAILY USE
Prepare the laundry by following the suggestions appearing under the
"TIPS AND SUGGESTIONS" section.
Rapid programming
- Press the ON/OFF button
; the START/PAUSE indicator light
flash slowly green.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the cycle table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments as described in "DETERGENT DISPENSER DRAWER"
section.
- Close the door.
STARTING CYCLE
Press the PUSH & GO button.
The machine will lock the door (
rotate; the door will be unlocked (
(
symbol on) as preparation phase of each washing cycle. The "Clicking"
noise is part of the door locking mechanism. Water will enter the drum
and start the washing phase once the door is locked.
Traditional programming
- Press the ON/OFF button
; the START/PAUSE indicator light
flash slowly green.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the Wash Cycle Table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments as described in "DETERGENT DISPENSER DRAWER"
section.
- Close the door.
- Use the WASH CYCLE selector knob to select the desired wash cycle: it
will be associated with a specific temperature and spin speed that can be
modified. The duration of the cycle will appear on the display.
- Modify the temperature and/or spin speed: the machine automatically
displays the maximum temperature and spin speed values set for the
selected cycle, or the most recently-used settings if they are compatible
with the selected cycle. Pressing the
temperature down to the cold wash "OFF" setting. Pressing the
gradually reduces the spin speed until it is completely excluded ("OFF"
setting). Pressing these buttons again restores the maximum values.
- Select the desired options.
STARTING CYCLE
Press the START/PAUSE
button.
The machine will lock the door ( symbol on) and the drum will start to
rotate; the door will be unlocked (
( symbol on) as preparation phase of each washing cycle. The "Clicking"
noise is part of the door locking mechanism. Water will enter the drum
and start the washing phase once the door is locked.
PAUSING A CYCLE
To pause the wash cycle, press the START/PAUSE
indicator light will flash amber. If the
opened. To start the wash cycle from the point at which it was
interrupted, press the START/PAUSE
OPENING THE DOOR, IF NECESSARY
Once a cycle starts, the
symbol turns on to signal that the door cannot
be opened. While a wash cycle is running, the door remains locked. To
open the door while a cycle is under way, for example, to add or remove
garments, press the START/PAUSE
indicator light will flash amber. If the
opened. Press the START/PAUSE
CHANGING A RUNNING WASH CYCLE
To change a wash cycle while it is in progress, pause the washing machine
using the START/PAUSE
button (the relative indicator light will flash amber),
then select the desired cycle and press the START/PAUSE
! To cancel a cycle that has already begun, press and hold the ON/OFF
button. The cycle will be stopped and the machine will switch off.
icon remains
symbol on) and the drum will start to
symbol off ) and then locked again
button gradually reduces the
symbol off ) and then locked again
button again; the
symbol is not lit, the door may be
button again.
button to pause the cycle; the
symbol is not lit, the door may be
button again to continue the cycle.
button again.
will
will
button
Werbung
