Assembly; Charging The Battery - MAXXMEE 03628 Gebrauchsanleitung

EN
1. Take the cover (12) off the device and
remove the battery (see the "Assem-
bly" chapter).
2. Place the base plate (10) in the lo-
cation you want and anchor it in the
ground using the three bolts (4) that
are supplied with the device. When
you do this, make sure that the base
plate is located in the middle of the
parking space. In addition, the front
of the bracket (13) must be pointing
towards the direction of approach.
3. Connect the battery and reattach the
cover to the device (see the "Assem-
bly" chapter).

ASSEMBLY

1. Remove the protective cap (8) for the
lock (9) on the back of the device.
2. Use the key (3) to open the lock.
3. Take the cover (12) off the device.
4. Place the battery on the base plate
and connect it to the motor unit by
connecting the barrel connector of
the motor unit to the socket connec-
tor of the battery.
5. Connect the battery to the solar
unit (7) by connecting the barrel
connector of the battery to the socket
connector of the solar unit.
6. Place the cover on the device.
7. Lock the lock to fix the cover on the
device.
The device is taken apart in the reverse
order.
14

CHARGING THE BATTERY

The battery of the device can be charged
either via the integrated solar unit (7) or
via the mains power.
It is essential that you charge up the
battery fully before you first use the
device in order to achieve the maximum
charging capacity. If the battery is fully
discharged during use, it must be fully
charged up again before it is next used.
Solar Unit
1. Insert the battery into the device and
connect it to the solar unit (7) (see the
"Assembly" chapter).
2. Place the device in a location where
the solar panel can absorb direct
sunlight all day long if possible. This
allows the battery to charge up during
daylight.
Mains Power
Please Note!
■
Make sure that the USB cable does
not present a trip hazard.
■
Do not charge up on a computer
because the computer might be dam-
aged by the high charging current.
■
Connect a USB mains adapter to a
plug socket that is properly installed.
It must be readily accessible so that
the connection to the mains can
quickly be isolated.
■
Disconnect the battery from the
power source if an error occurs during
charging or before a thunderstorm.
1. Remove the battery from the device
(see the "Assembly" chapter).
2. Connect the barrel connector of the
USB cable (6) to the socket connec-
tor of the battery and connect the A
connector to a suitable USB mains
adapter.