Polar GP295 Bedienungsanleitung Seite 5

Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.
The condenser is located behind the front bottom panel.
Note: Use a soft brush or vacuum cleaner to clean the fins of the condenser, taking care not
to damage the fins.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
The appliance turns on,
but the temperature is
too high/low
The appliance is
unusually loud
Error code EE4
GP295_ML_A5_v1_20231207.indb 5 GP295_ML_A5_v1_20231207.indb 5
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Too much ice on the evaporator
Condenser blocked with dust
Insufficient airflow to the fans
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
The appliance is touching a
neighbouring object
The appliance has not been
installed in a level or stable
position
• Restricted Airflow
• Blocked Condenser
Solution
Check unit plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Defrost the appliance
Clean Condenser
Remove any blockages to the fans
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Check installation position and change if
necessary
Check installation position and change if
necessary
• Increase airflow
• Consult a qualified Technician
EN
5
2023/12/7 13:38 2023/12/7 13:38