Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
13. Using the pendulum action
switch
The pendulum action switch is used to set
the way in which the teeth of the saw blade
grip the material. The pendulum action
switch can be set to 4 positions.
Do not set the pendulum position during
use.
Turn the pendulum action switch (9) to
required position according to the material
to be worked. Refer to the table below to
select the required position.
Material
Wood . . . . . . . . . . 1 — 3
Plastics . . . . . . . . . . . 1
Aluminium . . . . . . . . 0 — 1
Steel . . . . . . . . . . . . 0
Ceramics
. . . . . . . . . . 0
Rubber . . . . . . . . . . . 0
14. Dust removal
The saw is equipped with a changeover
switch for dust removal (7).
Set the switch to II to open the dust
14.1
outlet. The dust is thus blown away,
which improves the visibility of the cut-
ting line.
Set the switch to I to close the outlet.
14.2
When connecting a vacuum cleaner
(see next chapter), set the switch to the
I position.
15. Dust collection
This jig saw is a powerful tool that can pro-
duce a lot of sawdust. By connecting the jig
saw to a vacuum cleaner, a clean dust-free
operation is possible.
Do not use dust extraction when cutting
metal.
8
Pendulum position
Dust extraction is not possible for mitre
cuts.
Slide the dust nozzle (6) all the way into
15.1
the opening until the snap-in nose visi-
bly and audibly locks into place.
Connect the dust nozzle (6) with a vac-
15.2
uum cleaner or dust extractor.
When sawing wood, it is best to use an
additional dust protection mask since
wood dust is a health hazard.
16. The parallel stop
To cut parallel to a wood edge, you can use
the enclosed parallel stop (15).
In order to fix the parallel stop (15),
16.1
loosen the fastening screws (11)
slightly. Using the centimetre scale on
the parallel stop (15), you can adjust the
distance between the stop bar and the
saw blade.
Secure the parallel stop by tightening
16.2
the fastening screws (11) in the desired
position.
When not using the parallel stop, tighten
the fastening screws (11) securely. The
screws can be unscrewed and fall off
due to the vibration of sawing.
17. Laser
Safety instructions for the laser cut-
17.1
ting guide
a. Do not point the laser beam at persons
or animals and do not look into the
laser beam. This laser emits a laser
beam that falls under laser class 2 in
accordance with EN 60825-1:2014. You
could blind people with it.
b. A laser is not a toy and does not
belong in the hands of children. Using
it incorrectly may result in irreparable
damage to the eyes.
c. It is forbidden to manipulate the laser
so as to increase its power in any way.
No liability will be assumed for any
damages caused as the result of fail-
ure to comply with these safety
instructions.
d. The laser does not contain any ser-
viceable parts. Therefore, do not open
the housing. Otherwise, you will ren-
der the warranty void.
Werbung
