Operation With Timer; Automatic Re-Start After Electrical Failure - Hlc 3D Bedienungsanleitung

play. Press the START/STOP button in order to stop the instrument correctly,
and once you have solved the problem that causes these adverse conditions,
you can start the instrument again.

Operation with timer

First of all, adjust the desired value of RPM with the selection switches (˄ and
˅ buttons).
Press the MIN/RPM button, and the cursor will be located in the selected
time.
By means of the selection switches (˄ and ˅ buttons) adjust the desired
minutes. Note: if you select "0" minutes, the instrument will operate continu-
ously.
Press the START/STOP button, and the display will show (ON), and it will start
shaking softly and gradually, increasing the speed until it reaches the selected
one.
If the programmed minutes are reached, the instrument will stop automatical-
ly.

Automatic re-start after electrical failure:

In case of accidental cut off of the electrical supply, the instrument returns to
"ON" with the same adjusted parameters when the power returns. In the
display it will show the symbol "!" to indicate this situation.
Note: disconnect the instrument correctly; push START/STOP button and then
the mains switch. If it is not done this way, the instrument will understand
that an electrical failure has happened.
8