Parameter Setting - Hlc 3D Bedienungsanleitung

When activating the mains switch, the LCD display will light up, the instrument
will perform an auto check and the display will show the version of installed
software.
Once the instrument is initialized, the display will show the following:
First row: shows the actual speed and the elapsed time (initially zero)
Second row: shows the programmed speed and time of the last session. In the
middle of the row, it is indicated if the instrument is activated (ON) or not
(##).

Parameter setting

The cursor on the display initially is located in selected RPM. Press MIN/RPM
to change the cursor from RPM to MIN (time).
By means of the selection switches ( and buttons), adjust the desired val-
˄ ˅
ues. Note: if you push the ˄ and ˅ buttons simultaneously when the cursor is
in RPM position, the instrument will be adjusted to its maximum available
speed.
The touch the START/STOP key and the display will show (ON), the instrument
will initiate shaking in a soft and gradual way.
To stop shaking, touch START/STOP again. The display will now show (##).
Note: you can adjust the speed of the instrument while is working. For doing
so, use the ˄ and ˅ buttons.
*Safety system for motor protection: if the instrument surpasses maximum
motor power, it will be stopped and the message STOP is blinking on the dis-
7