SW-Motech HDG.00.220.30300/B Anbauanleitung Seite 12

1
 WARNING: Since the handguard mounting kit is installed in a safety-
relevant area of ​ ​ t he vehicle, SW-MOTECH recommends having the
installation/maintenance of the product carried out by a qualified specialist
workshop.
 WARNING: Always wear eye and hand protection!
 WARNING: Always use the proper tools!
 NOTE: Installation is shown on the left side. Repeat the installation with the
corresponding parts on the right side of the handlebar.
 NOTE: The handlebar shown serves as an example.
 NOTE: The connecting plate (2/3) shown in the drawing is for illustrative
purposes only. The correct image and orientation of the connecting plate are
shown in the detailed drawing on the right.
Place the clamps (1) around the handlebars at the locations shown in the
detailed drawing above.
Screw the connecting plates (2/3) to the clamps (1) LOOSELY. The clamps (1)
must remain movable for positioning.
 WARNING: Use a liquid threadlocker!
Tighten the screws (4) hand-tight.
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
4
2
1
×
1
2
×
1
3
×
2
4
×
M 8 Nm
Errors and omissions excepted
Subject to technical and design changes.