ARCADE1UP PacMan Benutzerhandbuch Seite 13

Troubleshooting
PROBLEM
Game will not turn on
Game will turn ON, but there is no
sound.
You hear sound but there is no
picture.
The game screen is frozen.
POSSIBLE CAUSE
-Power cord is not
plugged in to wall
outlet.
-Wires/Plugs may have
come loose during
shipping.
-ON/OFF Switch is in
the OFF position.
-Upload switch on back
of monitor is in the OFF
position.
*Wires/Plugs were
hooked up incorrectly.
*Volume is set too low.
*Wires/Plugs may have
come loose during
shipping.
*The game
encountered a
problem when
processing the data.
13
SOLUTION
-Make sure power cord is
plugged into the wall outlet
and there is power to that
outlet. (Plug other electrical
equipment into the power
outlet to make sure the
outlet normally works.)
-Make sure that no plugs are
loose. If loose or
disconnected, replug the
Wire/Plugs.
-Slide ON/OFF Switch located
on control deck to the ON
position.
-Slide upload switch on back
of monitor to the ON
position.
*Make sure all Wires/Plugs
are properly connected and
all the way set in as directed
in assembly instructions.
*Slide Volume Switch located
on control deck to the right.
NOTE: Push volume slide
switch right to increase
volume, left to lower volume.
-Unplug the arcade and
open up the access panel
on the back of the unit to
make sure that no plugs
are loose. If loose or
disconnected, replug the
Wire/Plugs and close the
access panel.
*Turn the ON/OFF switch OFF
and then back ON again.
*You may need to RESET the
game. Turn the ON/OFF
switch to the OFF position.
Unplug the game from the
wall outlet and wait 60
seconds to RESET the game.
Plug the game back in and
turn the ON/OFF switch back
to ON.