Inhaltsverzeichnis
Werbung
A. General safety instructions
Failure to observe the following precautions can result in significant injuries and damages!
The use of any machine is usually associated with certain risks. If the user takes all safety information provided by this
owner's manual into account, then the possibility of the occurrence of personal injuries and/ or damages to the workpiece
and/ or the machine can be reduced significantly.
This machine was designed for specific applications. We strongly recommend that this machine is not structurally altered or
that applications are performed for which the machine was not designed. If you have any questions regarding the application
of this machine, DO NOT use this machine until you have received detailed instructions for the proper use from your dealer or
by FLOTT.
è
Do not leave the running machine, leave only in case of stand-still of the machine.
è
Take attention to the instructions of the manufacturer regarding working material and highest speed
max feed, using of cooling materials and clamping device of the workpiece.
è
Only for original ,,FLOTT" spare parts we will take over the guarantee of a trouble-free factory.
è
The mains connector must always be unplugged before changing the corrugated abrasive wheel, before
opening the machine and before starting any conversions.
è
Before starting the machine connect all safety devices!
è
The machine should be connected to the main power supply as indicated on the machine information
plate.
è
Without supervision the machine should be unplugged.
è
The machine operator should wear tight - fitted clothes. Long sleeves should be rolled up, jewelry and
neckties should be removed prior to operation. Long hair should be tight up or covered.
è
Care must always be taken to ensure that the fingers are not trapped in the grinding gap when holding
and guiding the workpieces.
è
Use goggles or full face protection with side protection for all persons being in the working area of
the machine.
è
Workpieces which are too large for the warranted performance are permitted not be machined.
Workpieces which cannot be positioned correctly on account of their size or shape are permitted to be
machined.
è
Worn or damaged fan disks/brush disks must be removed immediately and be replaced by new ones.
è
Also in case of competent using and observance of all security rules there are remaining the following
risks are remaining:
- Accidental contact between fingers and the abrasive wheel.
- Danger due to electricity in general.
- Injuries due to tool parts being hurled aside.
- Kickback by the workpiece or parts of the workpiece.
- Danger due to the emission of physiologically harmful dust.
è
Grinding and polishing of aluminium parts and its alloys
Raised aluminium and magnesium dust can cause explosions, if there is an ignition source, like sparks or a
burning cigarette.
Hence it is necessary to exhaust the grinding dust with a seperate extraction system and to prevent
deposition of dust in the tubes.
Alternating grinding of spark arcing and non spark arcing materials is only permitted on especially
furnished grinding equipment. The grinding equipment must be provided with seperate grinding areas and
an extraction systems for the different dusts. In addition particular maintenance and purging intervals have
to be observed. Grinding equipment for alternated grinding must be flagged accordingly.
Information on necessary particular protective measures for the grinding of aluminium and its alloys can
be given at the competent offices of Technical Control of the respective employer´s liability insurance
associations. Details can also be viewed in the guidelines for reporting the dangers of dust fires and dust
explosions when grinding, brushing or polishing aluminium and its alloys (ZH 1/32).
370601 D/GB
GB
,
19
Werbung
Inhaltsverzeichnis
