Atlas Copco P2505 Sicherheitshinweise Seite 4

Safety Information
James McAllister, General Manager
Atlas Copco Ltd
Swallowdale Lane
Hemel Hempstead
Hertfordshire HP2 7EA
Regional Requirements
WARNING
This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more
information go to
https://www.p65warnings.ca.gov/
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below may result
in electric shock, fire, and/or serious injury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the product
cease to be legible or become detached, replace without
delay.
• The product must only be installed, operated and serviced
by qualified personnel in an industrial environment.
Intended Use
This product is designed for chipping, riveting, scaling, or
ramming, according to its operating instructions. No other use
permitted.
Product Specific Instructions
Installation
Installation of Vibrating Tools
We recommend using a minimum length of 300 mm (12") of
flexible hose for compressed air between a vibrating tool and
the quick coupling.
4 © Atlas Copco Industrial Technique AB - 9836 0662 02
General Installation Safety
Installation of Vibrating Tools
We recommend using a minimum length of 300 mm (12") of
flexible hose for compressed air between a vibrating tool and
the quick-action coupling.
Setting-up Instructions
WARNING Risk of Serious Injury or Death
Overspeed can cause serious injury or death!
Do not manipulate the speed of the tool.
►
Do not override the maximum speed marked on the
►
tool.
• Use a pressure regulator to prevent a too high air pressure
which can cause overspeed.
• Make sure that connections and the air hose are in good
condition.
Operation
General Operation Safety
Before Starting to Work
1. Tool check
• Always use a retainer.
• Inspect the retainer for wear and damage regularly.
• The accessories must be properly attached to the
tool.
• The tool and its accessories must not be modified in
any way.
• The trigger must never be removed or fixed by tape
for example.
• If the trigger is not working properly, make sure
that it is replaced.
• The air supply coupling should be separated from
the tool by a whip hose.
P2505