ATOMSTACK MAKER AC1 Benutzerhandbuch Seite 3

1 Declaration
ATOMSTACK MAKER AC1 camera functions need to be controlled by LightBurn, please download the official version of LightBurn
software. LightBurn is a third-party software, so ATOMSTACK service is not responsible for any loss caused by the operation of LightBurn,
the firmware of ATOMSTACK has been tested in detail by ATOMSTACK, and the situation of incompatibility with software or hardware is
still possible occur. If an error occurs due to incompatibility, you can contact our customer department service for technical support.
support@atomstack.com
2 Precautions
1. Do not collide or move the camera during the calibration process.
2. Do not collide or move the camera after the alignment of the calibration camera is completed. If the camera is collided and the camera
is shifted left and right, the camera lens and camera alignment need to be recalibrated.
3. Cardboard and dot cards need to be flat.
2