User Responsibility; Spare Parts List - Metabo Hdm 1000 Montageanleitung

User Responsibility

This machine will perform in conformity with the description contained in the instructions provided. This machine must
be checked periodically. Defective equipment (including power cables) should not be used. Parts that are broken,
missing, obviously worn, distorted or contaminated, should be replaced immediately. Should such repair or replacement
become necessary, it is recommended that such repairs are carried out by qualified persons approved by metabo.
This machine or any of its parts should not be altered or changed from standard specifications. The user of this machine
shall have the sole responsibility for any malfunction which results from improper use or unauthorized modification from
standard specifications, faulty maintenance, damage or improper repair by anyone other than qualified persons
approved by metabo or its representatives.
The optional workstand provides a stable base to mount the lathe on. The lathe is brought up to an ideal height for turning
operations.
Loin base plates 701 with brackets 702 placed inside at position A.
Attach legs 703 to base plates at position B.
Bolts struts 704 in between legs at position C.
Remove protective foil from back of rubber mat 705 and place mat into recess Z of base plates.
Mount machine on workstand, using outer set of holes for HDM 1000. Use hex. bolt M6x20, spring washer B 6.4 and
hex. nut M6.
To ensure maximum upright stability it is recommended to bolt workstand to floor. If floor is uneven compensate with
spacers.

Spare Parts List

Pos. Discription
701 Base plate
702 Bracket
703 Leg
704 Strut
705 Rubber mat
706 Hex. bolt
707 Hex. bolt
708 Spring washer
709 Spring washer
710 Hex. nut
711 Hex. nut
GB
Stock-no.
139 207 3791
139 207 4925
139 207 3805
139 207 3813
705 907 6218
610 300 1178
610 300 1135
630 400 1745
630 408 4047
620 000 2235
620 000 2219