Werbung
Verfügbare Sprachen
Verfügbare Sprachen
KEL 440 20110029
Quatro Universal Feed System, Digital
Features
The KEL 440 quatro universal feed system, connected to Kathrein multi-
switches or to signal processing systems, is intended for satellite reception
systems with four or more subscriber connections (max. 40 connections in a
cascade).
The use of a multi-switch or a signal processing system enables feed-in of
terrestrial signals.
The feed system is designed to receive Ku-band satellites, such as ASTRA,
EUTELSAT, Türksat and Hispasat.
Installation
Safety instructions
Before installing the feed system, read the safety instructions in the Kathrein
Euroline parabolic antenna user guide.
The safety instructions for parabolic antennas and feed systems are identical.
Installing the feed system
1. Clamp the feed system between the bottom and the top part of the feed
system mounting and tighten it loosely by means of the screw (Fig. 1).
2. See Fig. 2 for the polarisation setting angle.
3. Set the corresponding angle by tilting the feed system.
4. Screw the feed system mounting tightly (Fig. 3).
Connecting the cable
1. Slide the protective cap onto the cable, Kathrein type LCD 90, LCD 95A+,
LCD 111A+ or LCD 115A+.
2. Remove the insulation and screw the F-type connector* (e.g. EMK 01) onto
the end of the cable. Make sure that there is no contact between the wires
of the braided shield and the inner conductor (risk of short circuit).
3. Connect the F-type connector to the feed system.
4. Push the protective cap upwards until it locks in the opening of the feed
system casing.
*) Not included in the scope of delivery.
Fig. 2
All manuals and user guides at all-guides.com
Mirror Image
1
Fig. 1
Fig. 3
Quatro
Low H
High H
Low V
High V
Fig. 4
1 / 2
Werbung
