Using The Device - BOMANN SM 1916 CB Bedienungsanleitung

WARNING:
• This appliance shall not be used by children.
• Keep the appliance and its cord out of reach of children.
• Children shall not play with the appliance.
• Appliances can be used by persons with reduced physical, sen-
sory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of
the appliance in a safe way and if they understand the hazards
involved.
CAUTION:
• Do not use this appliance to chop up any hard food such as ice
cubes, nutmeg, or large pieces of cooking chocolate. This can
destroy the blade!
• This appliance is not designed to be immersed in water during
cleaning. Please follow the instructions that we have included for
you in the chapter on "Cleaning".
Instructions
• The appliance is designed for the mashing and mixing of
food and drinks.
• Chop up large pieces of solid food before mashing (max.
Ø 1.5 cm) and add a little liquid.
• The appliance is designed to process only small quanti-
ties of food! Fill the container with the maximum quantities
specified in the table!
• Adapt the capacity to the foaming behavior of the food to
be mixed. Decrease the amount if necessary.
• Pay attention to the slowing down of the motor after shut-
ting off.
• Short-time operating: Do not operate the appliance with
food for longer than 1 minute. Leave the device to cool
down for at least 10 minutes before using again.
Preparation
1. Take out all the parts carefully out of the packing.
2. Clean the device before using it for the first time as de-
scribed in "Cleaning".
28
Assembly
Assemble the motor housing and the hand blender as follows:
1. Place the hand-held mixer on the motor housing.
2. Now turn the mixer until the marks ( / ) are aligned with
one another.

Using the Device

1. Fill the food to be mixed into the mixing bowl (max.
700 ml). Immerse the hand blender in the mixing bowl. But
only immerse the mixing bar up to the MAX mark.
2. Electrical connection
• Check whether the electrical voltage that you intend to
use is the same as that of the machine. Details are to
be found on the label on the base.
• Only connect the machine to a properly installed safety
socket.
3. Please hold the device in such a way that you can operate
pushbutton I or pushbutton II with your fingers.
4. Press one of the buttons.
Pushbutton I:
This switches on the minimum speed
and cannot be regulated.