Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SAFETY
Parts drawing, Test Sheet, Warranty Slip, Approval Certificate.
•
In the event of Customers fitting a tool to the machine not supplied by
MAXVAC, make sure the safety conditions required by Machine Directive
2006/42/CE are complied with and in any event, MAXVAC is unable to
accept liability for any problems arising from use of such tool.
•
The vacuum cleaner must not be operated in a corrosive or explosive
environment.
•
Always make sure the vacuum cleaner is free of all foreign materials such
as debris, oil, equipment and other objects that could affect operation and
cause injury to persons.
•
Avoid using flammable or toxic solvents such as petrol, benzene,
ether and alcohol for cleaning.
•
Avoid prolonged contact with solvents and inhaling their vapours. Avoid use
close to open flames or sources of heat.
•
Never use the vacuum cleaner without the filter.
•
Do not vacuum lit cigarette ends. The filter could be damaged.
•
Do not vacuum petrol or flammable liquids in general.
•
Make sure all the guards and protection devices are in place and that all the
safety devices are in place and working properly.
•
Do not wear loose or hanging clothing such as ties, scarves or torn
garments that could become trapped and be sucked up by the cleaner.
•
Do not open the vacuum Longopac® container (if applicable) with the
machine running.
•
The manual should always be kept handy for reference so the operating
cycle can be checked every time there are doubts.
•
In the event of this manual being lost or damaged, ask MAXVAC for
a new copy.
•
Structural damage and improper alterations or repairs could change the
protection capacity of the vacuum cleaner and therefore cancel this
certification.
•
Any alterations to the appliance must only be made by MAXVAC engineers.
•
During maintenance jobs, affix a notice to the appliance indicating
"MACHINE BEING SERVICED, DO NOT START".
•
Climbing on the cleaner is forbidden.
•
Never touch electric wires, switches, buttons, etc. with wet hands.
•
Before connecting to the power mains, make sure the power voltage and
frequency are those shown on the machine plate.
14
SV1-430-MBS / SV1-430-MLS
MAX-VAC.COM
•
Make power connections to a mains supply with efficient earth system.
•
In the event of an extension being used, make sure this is in perfect
condition, marked CE and that the cross section of the cable is suitable for
the vacuum cleaner power input.
•
When restoring original working conditions, the appointed personnel should
make sure that at the end of the operating procedure, proper vacuum
cleaner operation safety conditions are restored, especially the safety
devices and the protective guards.
•
Only adult persons should use the vacuum cleaner.
•
During vacuuming operations, always brake the vacuum cleaner using the
special revolving wheel lock.
2.3 Safety plates and symbols
Plates are affixed to the vacuum cleaner showing safety symbols and/or messages.
2.4 Outstanding risks
Careful analysis of risks performed by the manufacturer and stored in the technical
ATTENTION!
Pursuant to articles L.D. 81/08, workers exposed to sound pressure
levels above 85 dB (A) must be protected by special individual
protection devices.
ATTENTION!
Read the operator's and maintenance manual carefully before using
the cleaner or doing any maintenance jobs.
IMPORTANT
Do not breathe in inflammable and/or explosive liquids or powders.
WARNING!
Risk of crushing upper limbs while fitting and locking the material
Longopac® container on the vacuum cleaner. Never place hands
between the material Longopac® container and vacuum cleaner while
locking. Do not place hands on sides of Longopac® container near
the guide pins while locking. Perform the Longopac® container locking
operation by means of the lever, USING BOTH HANDS!
SV1-430-MBS / SV1-430-MLS
MAX-VAC.COM
15
Werbung
