Lampa Amperomatic Bike Gebrauchsanleitung Seite 10

EN
BATTERY TYPES AND CAPACITY
• Suits 6V/12V lead acid batteries (STD, GEL, AGM) and 12V lithium batteries (LiFePO4).
• Battery capacity: the following maximum Ah capacities are to be used as a general guide only: some
batteries may be able to handle a higher charge current.
Check with the battery manufacturer when charging batteries with small capacity.
Charge current - 1A (6V/12V)
Battery capacity charging - 3-20Ah
Battery capacity maintaining - All battery sizes
CHARGING MODE
Amper-Smart has 4 charging modes as indicated in the table below. Some charging modes must restart
the charger and reconnect the battery.
Use the mode button to switch the mode to change the battery type. Before choosing, understand the
differences between each rechargeable battery mode.
Do not operate the charger before confirming whether the battery charging mode is suitable.
MODALITY Explanation
In standby mode, the charger does not charge or power the battery. In this mode, the
Standby
energy saving function is activated, and standby power is obtained from the power
outlet.
12V Std-
Used for 12V lead-acid batteries (STD and GEL). When selected, the white led will light
Gel up.
12V AGM
Used to charge 12V AGM batteries. When selected, the white led will light up.
12V Li-Ion
Used to charge 12V lithium battery, white led will light up when selected.
Used to charge 6V lead-acid battery, white led will light up when selected.
6V Normal
To select the 6V mode, you must press and hold the mode button for 3 seconds.
10