Electrolux WHGL9041CN Gebrauchsanleitung Seite 6

www.electrolux.com
6
4. CONTROLS
Button
L
T1
T2
T3
T4
T5
F
L T1 T2 T3 T4 T5 F
Basic function
Dual Function
Press briefly to turn the lighting system on and off.
Press and hold the button for 2 seconds to activate
the lighting system in "courtesy light" mode. The lights
are lit at a reduced power of approximately 5W. This
function can be disabled by pressing the button once
again for 2 seconds or by pressing it briefly to switch
to normal lighting mode.
Turns the motor off from whatever speed it is set to.
Press and hold the button for 3 seconds with all the
loads turned off (Motor and Lights), to turn the Activated
Charcoal Filter alarm on/off.
Turns the motor on at speed one.
When pressed briefly, turns the motor on at speed two. Button on
Press and hold the button for approximately 2" to turn
the Delay function on and off, that is to say to turn the
appliance off after a 20 minute delay. Suitable to com-
plete elimination of residual odours. Can be activated
from the OFF position and from speeds 1, 2, 3. Cannot
be activated with Intensive speed On.
Turns the motor on at speed three.
Turns the motor On and Off at Intensive speed for a
timed period of 5 minutes. At the end of the 5 minutes
the appliance will automatically return to the speed
that was set before. If the appliance was turned off at
the time of activation, at the end of the 5 minutes the
system will return to speed one.
Press and hold for 4 seconds to reset the filter alarm
indicator, shown by flashing of button T1. This procedure
can only be carried out with the motor off.
Indicator lights
Button off Lights off
Button lit Lights on
Button lit Courtesy light on
Button lit Motor active
Motor inactive
Button flashes twice F – Alarm On.
Button flashes once F – Alarm Off.
Button on
Speed two on
B u t t o n s Delay functionActive
f l a s h i n g
(T1+T2 or
T3 or T4)
Button on
Button on
Signals the Metal Grease
Filter saturation alarm,
indicating that it is neces-
Button on sary to wash the filters. The
alarm is triggered after the
Hood has been in opera-
tion for 100 working hours.
When this is activated,
it signals the Activated
Charcoal Filter saturation
alarm, indicating that the
filter must be changed;
Button the Metal Grease Filters
flashing must also be washed. The
Activated Charcoal Filter
saturation alarm comes
into operation after the
Hood has been working
for 200 hours.