Xblitz ARMOR 400 Benutzerhandbuch Seite 13

• Connect the camera to the power supply and wait un� l you hear an
audible no� fi ca� on.
• Press and hold the RESET bu� on for 5 to 10 seconds.
• Wait un� l you hear the „wait for connec� on" no� fi ca� on.
• The camera is ready to connect to the app on the phone.
• Make sure your phone is connected to the Wi-Fi network the device will
be connec� ng to. On the Armor 400 it is possible to connect to both
2.4GHz and 5GHz networks.
• Press the (+) symbol in the top right corner of the applica� on interface
or select „Add device".
• From the product categories, select „Camera & Lock" and then „Wireless
Camera (Wi-Fi or 2.4GHz&5GHz/Dual Band)".
• Ensure that the device is reset and ready to connect („wait for connec-
� on" message repeated).
4. Connec� on modes available
In the top right corner, select the camera's network connec� on mode and
proceed to the next step.
• QR code (recommended) - Connec� on mode by scanning with the
camera lens a QR code generated in the applica� on.
• Wi-Fi mode:
Mode AP - Connec� on mode via a hot spot created on the phone
(network name: „SmartLife-xxxx").
EZ mode - Automa� c mode. In this mode, the applica� on searches for
the camera itself.
• Cable - LAN connec� on via network cable.
Once the connec� on mode has been selected, follow the instruc� ons in the
app. The camera will inform you of the next connec� on steps with the sound
messages „connect router", „connect internet", „device access".
NOTE: do not disconnect the camera from the power supply during
connec� on.
Once the device is successfully connected, give it a name of your choice in
the applica� on.
5. Removing the device
On the home screen, hold down the tab with the name of any device. Then
select one or more devices you want to delete and click the recycle bin icon.
06. HOME SCREEN APPLICATION FUNCTIONS - SEE FIGURE C1
1. Change of resolu� on: HD/SD
When this op� on is selected, the quality of the displayed image in the
applica� on can be set.
2. Se� ngs:
• Device - possible to change the name of the device and add a loca� on .
• Device informa� on - informa� on on the device owner's account, IP
13