X-KOM G4M3R Bedienungsanleitung Seite 4

How to unpack the G 4 M 3 R computer
- read before you turn it on
01. Remove the accessory box
02. Lay the cardboard box on its side edge
03. Grasp the extrusion and slide the computer out
of the carton
Before you switch on the computer
We stably install all components inside the computer.
In some cases, we use a shipping filler. If it is inside the
computer, remove it before turning on the computer.
01. Remove the screws securing the glass panel
02. Carefully slide out the panel
03. Pull out the filler
04. Carefully slide the panel in
05. Tighten the screws
How to prepare the computer for work
Connect the monitor.
Plug the monitor cable into the appropriate connector on
the graphics card. If you are using an HDMI cable - make
sure the cable is compatible with version 2.0 or higher.
The layout of the connectors may be different from the pic-
ture, it depends on the model of the graphic card. Different
types of connectors look like this:
DVI VGA
HDMI Display Port
If the plug of the cable does not fit the
connectors on your computer, use a
suitable adapter.