Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. CONTROLS
L
Button Function
L
Turns the lights on/off at maximum strength.
Press and hold the button for approximately 2 seconds to turn the Courtesy
Lights On/Off.
T1
Turns the motor on/off at speed one.
T2
Turns the Motor on at speed two. Press and hold the button for
approximately 5 seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm on. The relevant
LED flashes twice to confirm. To turn the alarm off, press the button
again and hold for at least 5 seconds. The relevant LED flashes
once.
T3
Turns the Motor on at speed three. Press and hold the button for
approximately 3 seconds, with all the loads turned off (Motor and
Lights), to perform a reset. The LED S1 flashes three times.
T4
Turns the Motor on at INTENSIVE Speed. This speed is timed
to run for 6 minutes. At the end of this time, the system returns
automatically to the speed that was set before. If it is activated with
the motor turned off, the hood will switch to OFF at the end of the
time. Press and hold for 5 seconds to enable the remote control,
indicated by the LED flashing twice. Press and hold for 5 seconds to
disable the remote control, indicated by the LED flashing just once.
S1
Signals the Metal Grease Filter saturation alarm, indicating that it is
necessary to wash the filters. The alarm is triggered after the Hood
has been in operation for 100 working hours.
When this is activated, it signals the Activated Charcoal Filter
saturation alarm, indicating that the filter must be changed; the Metal
Grease Filters must also be washed. The Activated Charcoal Filter
saturation alarm comes into operation after the Hood has been
working for 200 hours.
T1
T2
T3
T4
ENGLISH
7
S1
Led
-
-
Fixed.
Fixed.
Fixed.
Fixed.
Fixed.
Flashing.
Werbung
