Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The adapter is mounted in reverse order. Hold the adapter above the bore of the monitor mount
and insert with the bolt. Ensure that the bolt is first inserted through the round bore and immerses
in the square-cut bore on the opposite side. Tighten the bolt with washers. Press the plastic co-
vers onto the adapter. The cover with the bore hole must be on the side where the screw is.
Through the bore in the cover, the retention force respectively sluggishness of the tilt regulation
can be set by adjusting the screw.
Maintenance, cleaning and repair
u Maintenance: Regularly check if the screw connections are tight.
u Cleaning: Use a slightly damp cloth to clean the desktop adapter. Do not use chlorinated or
u
abrasive cleaning agents. These may cause damage to the surface and paint.
u Repair: Immediately repair any damage that occurs and stop using the adapter. Maintenance
u
work may only be carried out if you have the necessary knowledge. If any parts are missing,
u
contact the manufacturer at www.k-m.de.
Fault and troubleshooting
Fault/cause
Adapter wobbles or does not hold
position on monitor mount
Attached accessories wobble or
wiggle on adapter
Storage, disposal
Store the adapter in a dry place.
Recycle disassembled components:
u Scrape all components made of metal.
u Recycle or reuse all plastic, paper, and cardboard components.
u Sort all other components according to material composition and dispose of them
u
according to local regulations.
Kontaktinformation
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2
97877 Wertheim
Germany
23881-300-55 / 23881-500-55 Rev.05 / Rev.04 03-80-060-00 3/22
In order to fit the adapter to the monitor mount,
you should first remove the installed screen bra-
cket. To do this, pull off the two plastic covers on
the monitor mount. Unscrew the screw under-
neath with the provided Allen key and remove
screw and washers. Hold the screen bracket and
remove the bolt.
Check/Remedy
● Check screw connection between adapter and monitor
●
mount, tighten if necessary
● Check screw connection between both components
●
and tighten if necessary
Phone: +49 9342/8060
Fax: +49 9342/806-150
E-Mail: contact@k-m.de
Web: www.k-m.de
Werbung
