Feig Electronic BBID i-scan ID ISC.M02 Montageanleitung Seite 21

®
OBID i-scan
4. Funkzulassungen
4.1. Europa (CE)
Die Funkanlage entspricht, bei bestimmungsgemäßer Verwendung den grundlegenden Anforde-
rungen des Artikels 3 und den übrigen einschlägigen Bestimmungen der R&TTE Richtlinie
1999/5/E6 vom März 99.
Equipment Classification gemäß ETSI EN 300 330: Class 2
4.2. USA (FCC)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Unauthorized modifications may void the authority granted under Federal communica-
tions Commission Rules permitting the operation of this device.
This device is labeled with an FCC ID number.
If this label is not visible when installed in an end device, the outside of the device MUST
also display a label referring to the enclosed module.
Wording on the label similar to the following shall be used:
This device contains transmitter module FCC ID PJMISCM02
At the time of this printing, the antennas listed below were the only antennas approved for
use with the ID ISC.M02 module. Use of other antennas must be approved by
FEIG ELECTRONIC GmbH.
Antennas approved: ID ISC.ANT100100; ID ISC.ANT4030
FEIG ELECTRONIC GmbH
Montage
FCC ID: PJMISCM02
Page 21 of 44
ID ISC.M02
M20301-2de-ID-B.doc